Rocaris 30 Pack 1/4 Inch Hex Shank Long Magnetic Screwdriver Bits Set 6 Inch Power Tools(Slotted+Cross+Square +Torx)

muy bueno

I use them all the time. They work great. I take them in and out through the bottom as it works the easiest

These seem pretty cheap low quality made but they are also priced cheap so I didn't expect anything else. I needed one of these one day and couldn't find any local at all to buy so I bought this cheap set just to have around in case the need arises again.

The tips of the drivers fit tight in their slots. The shafts are magnetized for their entire length.

Very handy for hard to reach screws

I was totally ready to love this product. All the bit types and sizes I wanted with the length I wanted, but these were just too low quality. I have other Phillips and t25 6” bits and the difference in quality when using other bits is astounding. They were deforming within the first use and after that couldn’t drive anything if not perfectly aligned. Some high quality manufacturer should be selling a set like this! Also they would stick in the impact as they were not properly sized and machined for a 1/4” shank

these long-shafted drivers were what I was looking for but I hesitated due to the high price. I ended up buying them anyway but having buyers remorse due to the lack of quality. Some of the tips have a 'ragged-edge', just not good fit and finish. Having to spend $33.00 added insult to injury. I'm not going to return them; I'll touch up the tips that are bad with the dremel but I wouldn't recommend buying them.

Exactly what I was looking for and came in a nice pouch. Good quality.

I ordered this set for 3 or 4 of the pieces. The Torx, Phillips an Robertson heads are just what I wanted and it was a bonus that they had multiple sizes of each. Being magnetic and 6", just what I wanted.

Great kit, very useful, but bits are a little soft. The cost if low for such a big kit, so of course it is to be expected that the durability will not be there. Overall I would say it’s worth it as you get many bits to access smaller holes for appliance repair, etc, but if you encounter stuck fasteners, the bit might strip easily. Just don’t go too hard, I would say it’s hand tools not to be used with a drill much. Still worth 4 stars because of the value.

Je l'utilise à tous les jours à mon travail au garage c'est aimanté et long quand même sa vaut la peine tu as plusieur

Absolute garbage. The Robertson bits don’t even fit. None of them.

Shafts are quite soft and can’t take much torque (twisted 2 like licorice) Sizing is off enough a #2 Robertson bit doesn’t fit a #2 screw